No Rinse Self Foaming Sanitiser
Simply dilute 10ml to 5 litres of tap water. Apply to all surfaces via immersion or spray or clean cloth. If you mix the sanitiser with your tap water and it turns cloudy, then the pH may be too high, or the mineral composition of your water is affecting the product. In this case it is recommended that you use bottled water.
Manufactured in the UK.
BENEFITS
No Rinse required when used at the recommended dilution
Self Foaming
Not Affected by Organic Materials
DESCRIPTION
A blend of phosphoric acid, benzenesulfonic acid and isopropanol.
A self-foaming sanitising solution
An excellent sanitizer for manual application
Not recommended on soft metals because of the acid nature of this product.
GENERAL USE DIRECTIONS
Dilution: 0.2%, 10ml to 5litres of water
Higher concentrations will require a potable rinse
All surfaces should be cleaned and rinsed beforehand
Minimum contact time 2minutes
The solution should remain at a pH at 3 or below to maintain proper sanitizing level.
If using the diluted solution over time, check the PH regularly using Ph papers
Hand Utensils, Tanks, Vats, Homebrew use:Scrape or pre-clean dirty surfaces. Clean all surfaces using a suitable detergent, following label directions. Rinse with potable water.
Apply diluted solution on surfaces with a cloth, mop ,brush, sponge, spray or by immersion.
After 2 minutes contact time, drain solution thoroughly.
For all applications, allow to air dry, however surfaces must remain wet for at least two minutes.
Do not rinse after Chemsan application.